"
What are you using in its place? I had the same issue updating to 20.7.4. It caused a mess. I finally switched to dnsmasq. I have been reluctant to update or go back to unbound. I'm kind of in limbo waiting for an all clear.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
21.1 Legacy Series / Re: Unbound and BlackLists - restarted when interface wakes up? (is delay...)
March 09, 2021, 06:19:28 PM #2
General Discussion / Re: Unbound blacklist clarification
February 25, 2021, 08:37:35 PM
Thank you.
#3
General Discussion / Re: Unbound blacklist clarification
February 25, 2021, 03:30:24 PM
Yes, thank you. I have many aliases set up this way. As far as I can tell they will only populate with a*.txt file. I cannot find a file of this format for the yoyo list. Have you?
#4
General Discussion / Re: Unbound blacklist clarification
February 25, 2021, 02:11:29 AM
I am not sure which way is better, firewall rules or dnsbl, but I cannot figure out how to populate the list into an "Alias". How did you accomplish this?
#5
Intrusion Detection and Prevention / Re: Would it make sense to outsource rules to firewall rule
February 07, 2021, 06:26:15 PM
I realized about a 50% increase in speed by doing this.
#6
20.7 Legacy Series / Re: Static DHCP
November 17, 2020, 02:23:57 AM
Your static mappings need to be outside of the range chosen for auto mapping.
#7
Intrusion Detection and Prevention / netflow traffic graphing not working
September 03, 2020, 02:36:50 AM
Since I enabled ids/ips the traffic on the interfaces chosen is no longer graphing on the netflow traffic graph.
Any way to have both ids/ips and graphing?
OPNsense 20.7.2
Suricata 5.0.3 running in system mode
Any way to have both ids/ips and graphing?
OPNsense 20.7.2
Suricata 5.0.3 running in system mode
Pages1
