Messages

Thanks, but that wasn't the key to it. I had heard that 5060 wasn't always UDP. When I look at the live logs and then make a phone call, there is a "default" rule somewhere blocking this port 5060

[NAT: Port Forward]

I have forwarded a total of four ports successfully and have tested them for passthrough but for some idiotic reason, I am unable to open SIP 5060 UDP for one VOIP phone behind the OPNsense. I have used the exact same firewall rules for all of them but this 5060 just won't work.

CISCO IP PHONE SPA504G has a static IP address (and I changed that just for kicks to see)

Firewall:

NAT: Port Forward
   
Interface -->   WAN
TCP/IP Version -->   IPv4
Protocol -->   UDP
Source Port Range -->   Advanced / any-any
Destination -->   WAN Address
Destination port range --> from: SIP   to: SIP
Redirect target IP --> Phone (Alias set up as 192.168.0.10)
Redirect target port --> SIP
Pool Options --> Default   
Description --> VOIP
NAT reflection --> Enable
Filter rule association   --> Pass

Thank You in advance ...