1
General Discussion / SIP Port 5060 Just Won't Forward
« on: June 08, 2020, 05:26:59 pm »
I have forwarded a total of four ports successfully and have tested them for passthrough but for some idiotic reason, I am unable to open SIP 5060 UDP for one VOIP phone behind the OPNsense. I have used the exact same firewall rules for all of them but this 5060 just won't work.
CISCO IP PHONE SPA504G has a static IP address (and I changed that just for kicks to see)
Firewall:
NAT: Port Forward
Interface --> WAN
TCP/IP Version --> IPv4
Protocol --> UDP
Source Port Range --> Advanced / any-any
Destination --> WAN Address
Destination port range --> from: SIP to: SIP
Redirect target IP --> Phone (Alias set up as 192.168.0.10)
Redirect target port --> SIP
Pool Options --> Default
Description --> VOIP
NAT reflection --> Enable
Filter rule association --> Pass
Thank You in advance ...
CISCO IP PHONE SPA504G has a static IP address (and I changed that just for kicks to see)
Firewall:
NAT: Port Forward
Interface --> WAN
TCP/IP Version --> IPv4
Protocol --> UDP
Source Port Range --> Advanced / any-any
Destination --> WAN Address
Destination port range --> from: SIP to: SIP
Redirect target IP --> Phone (Alias set up as 192.168.0.10)
Redirect target port --> SIP
Pool Options --> Default
Description --> VOIP
NAT reflection --> Enable
Filter rule association --> Pass
Thank You in advance ...