Messages

Just now, I checked the related settings and found that I have enabled the option to enable the local address of the link. I'm sorry that I didn't notice this problem at all. I withdrew this option and it is normal after restarting.

That's weird. Why is there a problem in my system?

Under normal circumstances, when I restart the system, it should look like this:

My opnsense is not directly connected to the ISP. Its superior equipment is proxmox ve (using openvswitch) and vyos router deployed in the industrial control soft route D525. Opnsense runs in switch mode instead of routing mode. This IP is only the IP of opnsense's web management background. According to the expected execution, it should be able to take effect through IPv6 and IPv4. After restarting, both IPv4 and IPv6 can go online at the same time. However, after I manually set IPv6 and IPv4 to take effect, only IPv4 is effective after restarting. I must reapply the interface. This abnormal.

When the firewall policy is updated, the interface appears unreachable page.
As attachment:

Like attachment, the IPv6 address I set will not be applied unless I enter the interface to reapply the configuration.

I created two VLAN sub interfaces (P1 or P2), which use static IPv4 + static IPv6, but only IPv4 takes effect after restart.

When IPv6 and IPv4 coexist, the static IPv6 address setting is invalid by default after reboot. Am I wrong?

ipv6和ipv4共存情况下，静态ipv6地址设置在重启后默认无效，是我配置错了么？