Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - agl

#1
Hello, I am a newbie as far as OPNsense or Wireguard is concerned.

I have looked quite far in this forum: I have only ever seen IPv4 addresses as the endpoint address for Wireguard. Is it possible to also use an IPv6 address for the endpoint address in Wireguard?

I did my configuration according to the https://docs.opnsense.org/manual/how-tos/wireguard-client.html and I selected "IPv4 + IPv6" everywhere it was specified, but it doesn't work. It only works with the IPv4 endpoint address.

Can the Wireguard server handle IPv6 traffic on the endpoint at all? Or is this a problem of OPNsense?

I have the same problem with OpenVPN! Also here only an IPv4 address works as endpoint address.

Best regards
Andreas
#2
19.7 Legacy Series / Re: 19.7.2 DHCPV6 refuse to lauch
September 05, 2019, 10:44:03 PM
Quote from: virtual_francky on August 21, 2019, 04:01:40 PM
I did the upgrade this morning from 19.7.1, and since then, DHCPV6 refuse to lauch. Any thing has changed ?

I fount that the dhcpv6 server runs when you use 64 bit for the prefix delegation size. So you can only switch on ipv6 on one interface (with "IDv6 Prefix ID" 0).