"
Hallo M@rch0n,
that was exactly the information I needed!!!!
Thank You very much ! :)
that was exactly the information I needed!!!!
Thank You very much ! :)
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / Newbie Question: Changing NAT Rules via SSH
June 22, 2019, 02:40:32 PM
Hallo,
I am new to the OPNSense Firewall and havend got the whole scope of what the OPNSense can and can't do.
I have a specific task wich I hope, the OPNSense can do.
I have a Failover-Setup from 3CX local. The Second 3CX watches the first 3CX and if the first one fails, a script is executed wich must switch the Internal DNS (which is used to provision all devices) and the portforwarding Rule for the Port 5060 from one IP to another.
The DNS is already taken care of but I need a appliance which allows the change of the Port-Forwarding via SSH.
Can someone tell me, if this is possible and how?
Thank You very much,
Daniel
I am new to the OPNSense Firewall and havend got the whole scope of what the OPNSense can and can't do.
I have a specific task wich I hope, the OPNSense can do.
I have a Failover-Setup from 3CX local. The Second 3CX watches the first 3CX and if the first one fails, a script is executed wich must switch the Internal DNS (which is used to provision all devices) and the portforwarding Rule for the Port 5060 from one IP to another.
The DNS is already taken care of but I need a appliance which allows the change of the Port-Forwarding via SSH.
Can someone tell me, if this is possible and how?
Thank You very much,
Daniel
Pages1
