"
Can you link for the forum post for "opposing unicast address"?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / pfSync problem on 18.7.9
December 29, 2018, 09:36:30 PM
I have two hosts with a back to back cable on igb0. They have IP addresses on the CARP interface (lan) of 10.255.255.2/24 and 10.255.255.3/24. I have enabled Synchronize States on both hosts on that interface. I have left the peer to the default (empty) value (multicast I assume).
However, this is not working. When I tcp dump on the igb0 interface on both hosts, there is no traffic with the pf states...
I'm not sure how to debug this. I've tried setting the peer IP address to the IPv4 address of the partner, and that didn't change anything either.
However, this is not working. When I tcp dump on the igb0 interface on both hosts, there is no traffic with the pf states...
I'm not sure how to debug this. I've tried setting the peer IP address to the IPv4 address of the partner, and that didn't change anything either.
Pages1
