Messages

I had the same thing happen.

I went to the squid config page, support and 'reset' and that seems to have settled the problem down.  At least for 5 minutes.

With that hardware I'd look at these two possibilities.

1. Overheating.  Is there sufficient space around it for cooling?  Nothing on top?  Is the heatsink up?  Try aiming a fan of some sort at the unit, see if that makes a difference.

2. Bad RAM.  Download memtest86 and write it to a USB drive then let it run for a couple of hours.  Any reported RAM faults is cause to swap the RAM out.

I'll reply for everyone else.  (nothing like putting words in the mouths of 10,000 other people who didn't even know the question was asked ).

We rely on those who know the subject better than us to make sensible decisions to be the default.  We don't have enough knowledge of the benefits and drawbacks of either.    We have you own jobs and problems and knowledge base.   The details of apinger & dpinger, we don't have that.

If there are good reasons to be using dpinger and not apinger, why haven't you changed the setup in the firewall already?


But, specifically, for me.

1. no
2. what ever the default is
3. insufficient knowledge to make an informed decision
4. insufficient knowledge to make an informed decision
5. insufficient knowledge to make an informed decision, but YOU made the choice to use apinger, it must be your preference, so i went with that.