Messages

1

17.7 Legacy Series / Re: Traffic shaper rule orders

« on: January 10, 2018, 09:11:19 am »

Thanks, I assumed that was the case but was hoping there was a way to do both at once.

2

17.7 Legacy Series / Traffic shaper rule orders

« on: January 10, 2018, 08:16:59 am »

Hi,

I'm still fairly new to opnsense and have query about the traffic shaper. When traffic flows through the system and matches a rule does it end at that rule or also continue on until it has been compared to all the rules?
E.g. if I follow the example config but want to have the system allow 1 Mbit per user but no more than 40 Mbit for the whole system is it important which order they go in / will it match the 40 Mbit rule if that is first and ignore the 1 Mbit / IP rule?

Thanks in advance
Simon

3

General Discussion / Re: Limit speed by 1 user many devices Captive Portal

« on: November 12, 2017, 02:38:40 am »

I'm interested in being able to do this as well, I haven't had a chance to do much testing but my understanding of how the traffic shaping works in the back ground I am not sure it is possible as it is looking at the traffic type / IP addressing rather than the auth source.
If there is someone out there that has tried something similar suggestions would be appreciated even if it is just a confirmation of if it is possible or not.

Regards
Simon

4

17.1 Legacy Series / Re: Cannot create captive portal Zone

« on: July 01, 2017, 11:09:41 am »

For anyone else that encounters this issue a reinstall fixed the problem, not sure why it didn't work on the first fresh install though.

Simon

5

17.1 Legacy Series / [SOLVED] Cannot create captive portal Zone

« on: June 30, 2017, 01:56:51 pm »

Hi All,

I'm hoping someone can point me in the right direction, I've just done a fresh install of Opnsense to replace a PFsense install that is acting up however I can't get the captive portal to do, well anything. When I go to Captive portal -> administration click the + sign to create a new zone and hit save changes it gives no error but also does not create the zone.
I have tried looking Via the CLI and about the closest I can fine is that the /etc/rc.conf.d/captiveportal file has captiveportal_enable="NO" and manually changing that to YES makes no change plus a reboot resets it to NO.
This is a fresh install updated to the latest version installed within ESXi:
OPNsense 17.1.8-amd64
FreeBSD 11.0-RELEASE-p10
OpenSSL 1.0.2l 25 May 2017

Any suggestions would be appreciated as I'm out of ideas as to what is preventing the zone creation.

Regards
Simon