"
Didnt mess with the MAC Address and we use static WAN IPs.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
17.1 Legacy Series / Re: WAN port replacement wont connect to internet
July 30, 2017, 08:46:19 PM #2
17.1 Legacy Series / WAN port replacement wont connect to internet
July 30, 2017, 11:23:59 AM
Hello all,
A port on my NIC started to act up so I need to put it on a new port. I copied over its IP/gateway, Firewall rules, and NAT says it was using auto outband with the interface. Yet, I still cant connect to the internet. I've tried pinging 8.8.8.8 or using tracert directly from the WAN interface but nothings getting through.
Any thoughts on possible troubleshooting steps I could go through?
Thanks!
A port on my NIC started to act up so I need to put it on a new port. I copied over its IP/gateway, Firewall rules, and NAT says it was using auto outband with the interface. Yet, I still cant connect to the internet. I've tried pinging 8.8.8.8 or using tracert directly from the WAN interface but nothings getting through.
Any thoughts on possible troubleshooting steps I could go through?
Thanks!
Pages1
