1
17.1 Legacy Series / WAN port replacement wont connect to internet
« on: July 30, 2017, 11:23:59 am »
Hello all,
A port on my NIC started to act up so I need to put it on a new port. I copied over its IP/gateway, Firewall rules, and NAT says it was using auto outband with the interface. Yet, I still cant connect to the internet. I've tried pinging 8.8.8.8 or using tracert directly from the WAN interface but nothings getting through.
Any thoughts on possible troubleshooting steps I could go through?
Thanks!
A port on my NIC started to act up so I need to put it on a new port. I copied over its IP/gateway, Firewall rules, and NAT says it was using auto outband with the interface. Yet, I still cant connect to the internet. I've tried pinging 8.8.8.8 or using tracert directly from the WAN interface but nothings getting through.
Any thoughts on possible troubleshooting steps I could go through?
Thanks!