"
For me it was causing acme-client plugin. I had a newer installation so I upgraded it to 20.7 and everything worked fine. Then I installed acme-client and I had a few issues. I couldn't get a certificate, there were also some php warnings and the syslog-ng started to crash. I tried restart opnsense several times (also with Let's encrypt plugin disable) and after every restart syslog-ng crashed and couldn't be started. So I tried to remove the acme-plugin and after restart syslog-ng was working again. I tried another testing restart and syslog-ng was still working. So the problem was acme-plugin (some of its dependencies probably) which have some problem with syslog-ng.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
20.7 Legacy Series / Re: syslog-ng - stopped working after recent upgrade?
August 23, 2020, 05:50:50 PM #2
17.1 Legacy Series / Re: <SOLVED> Apinger dont start after update to 17.1.7
June 15, 2017, 04:46:22 PM
Great, thanks, I had the same with apinger not running. After editing and saving without any changes it works again.
#3
General Discussion / Port forwarding - from one port to another
February 29, 2016, 11:10:43 AM
Hi,
I am trying to figure out how to port forwarding if I want to to access more computers on the same port, because I don't want to change the default port of the services. For example, I put xxx.com:9090 and it will redirect to specific LAN to port 80. Here is example and red is marked what I tried but it doesn't work.
I am trying to figure out how to port forwarding if I want to to access more computers on the same port, because I don't want to change the default port of the services. For example, I put xxx.com:9090 and it will redirect to specific LAN to port 80. Here is example and red is marked what I tried but it doesn't work.
Pages1
