Messages

@Marjohn56: Thanks. Found it!

humm... ok. well I'll keep a watch on this setting and hoping it will show up again with the next update of opnsense :-)

I just added a security header in nginx, did reload the sever and it works. So I think that reload should work for you HunvHunv.

I did reboot opnsense yesterday and waited until today to boot a laptop to see what happens.
And indeed, the laptop did show up in DHCPv6! so I will do that with other devices also. thnx for the depreciated hint.

I also noticed that with the reboot of opnsense my wan ipv4 stayed the same as normal. But my ipv6 did change.
Than I remembered the guide: https://homenetworkguy.com/how-to/configure-ipv6-opnsense-with-isp-such-as-comcast-xfinity/

interfaces - WAN - prevent release (see the attached picture from that guide website)

I can not find that setting on interfaces - wan page. Where is this setting now?

thnx. sounds like a possibility. I will reboot some devices and opnsense to see what happens...

Router Advertisements is set to [managed]

Can there be SLAAC generated addresses while I have set opnsense to [track interface]?
under opnsene-interfaces-lan-IPv6 Configuration Type -> Track interface

My ISP has just enabled ipv6.

I followed this guide: https://homenetworkguy.com/how-to/configure-ipv6-opnsense-with-isp-such-as-comcast-xfinity/
and all works and I have ipv6.

under Services - DHCPv6 - leases I can see some devices and make lease type static. But why are not all ipv6 devices showing up? When I look in AdGuard Home I can see the other devices working and dns queries, but they do not automatically show up in opnsense-services-DHCPv6. Is this a bug? Or what do I have to do?

I just hit update in AdGuard Home and it updates itself.

Dear Wusikijeronii,

Did you tick [disable web GUI redirect rule] when changing ports en setting to https? (system-settings-administration)
I think this (older) guide wil help you: https://medium.com/@jccwbb/website-protection-with-opnsense-3586a529d487
(chapter 6)

thnx cookiemonster, I have changed some OPN settings and see if the booting works.

*update: rebooting not solved. I have to start adguard manually.

I am not familiair with rc.syshook. Does anybody know how to utilize this? What script, where, how for "use rc.syshook framework to load AdGuard in "early" stage"

Thanks Mimugmail for your reply. I have a couple of questions:
1.

Unbound listen to localhost only

I can only select LAN, WAN, WG, So I select LAN or is there a custom field to being used?

2.

General DNS Server empty

I have that empty already. Check.

3.

AdGuardHome only listen to LAN address.

Can I change this in my AdGuard Home settings when I have it already up and running? Can't find how to change it in the GUI.

I have the same problem. Would be awesome to being able to solve this.

@Felix.
Thanks! That fixed it for me also!

Question about the config of Adguard Home: Is there a way to backup and restore the adguard home config?
Or is this already being added to the opnsense backup config file?