1
General Discussion / OPNsense "broken" after first reboot
« on: March 30, 2023, 08:23:46 pm »
Hello all!
I have installed OPNsense on a Fujitsu Futro S740. In addition to the standard Ethernet port, I have installed a PCIE M.2 A + E to RTL8111F - RJ45 network card.
After installation, the futro boots normally, I plug cables into WAN and LAN. LAN goes directly into the PC. The PC gets an IP assigned and I can access the webinterface. I don't have to change the default interface settings for testing. This is how it looks like: https://imgur.com/gCm6Af3
Until then everything is normal. When I do a reboot, everything looks also ok in the log on the connected screen. The interfaces are listed with correct IP. However, I can no longer reach the Futro in any way via the LAN interface.
If I perform a reset via plugged in keyboard, the whole thing starts from the beginning.
I am absolutely clueless.
I have installed OPNsense on a Fujitsu Futro S740. In addition to the standard Ethernet port, I have installed a PCIE M.2 A + E to RTL8111F - RJ45 network card.
After installation, the futro boots normally, I plug cables into WAN and LAN. LAN goes directly into the PC. The PC gets an IP assigned and I can access the webinterface. I don't have to change the default interface settings for testing. This is how it looks like: https://imgur.com/gCm6Af3
Until then everything is normal. When I do a reboot, everything looks also ok in the log on the connected screen. The interfaces are listed with correct IP. However, I can no longer reach the Futro in any way via the LAN interface.
If I perform a reset via plugged in keyboard, the whole thing starts from the beginning.
I am absolutely clueless.