NTP problems only IPv4

[tillsense]

Hi,
i noticed that the time after the new connection is no longer synchronous. Since I wanted to do a test with only IPv4 anyway i changed the ntpd.inc a bit and after a restart of the service the protocol log also showed these start parameters and the service ran without ipv6 sockets.

After restarting OPNsense these start parameters are not used according to the protocol log output and the sockets confirm that ipv6 is running. An immediate restart of the service causes again the correct start with the changes and also the missing of the ipv6 sockets confirm this again?

My guess is that something seems to be wrong with the sequences?

cheers
till

[tillsense]

Hi,

changed the Topic because here the wan ip doesn't change directly (double nat). Can I configure a pure ipv4 ntp operation via the extended field in the Gui? I haven't been able to do that so far.

cheers
till