Home
Help
Search
Login
Register
OPNsense Forum
»
Archive
»
18.7 Legacy Series
»
DNS packets are the only ones that seem to do anything
« previous
next »
Print
Pages: [
1
]
Author
Topic: DNS packets are the only ones that seem to do anything (Read 3431 times)
tre4bax
Full Member
Posts: 151
Karma: 4
DNS packets are the only ones that seem to do anything
«
on:
September 15, 2018, 06:08:05 pm »
Having fought OpnSense for a bit I now seem to have achieved a connection to the internet.
My only issue right now is that only DNS queries seem to travel it! Looking at the status page in routes I am struggling to understand what is there as it talks about Link#3 and Link#9 with no reference to what those are. However as I can make NSlookup queries against 1.0.0.1 I am assuming that routing is actually working.
This means that something else is stopping me getting information too and from the internet. I thought the basic setup of OpnSense would get things basically working. Seems something might be missing though and again I need pointing in the right direction.
I have IPv4 "Any" rules defined by default in the LAN firewall rules as part of the setup and I thought that this would be all I needed firewall wise. There are now Floating or Wan rules. Similarly NAT is set to Autogenerate only so again I thought I would be okay. Essentially I have done a factory reset, configured the local LAN on 192.168.0.x/24 and the WAN as PPPoE with my broadband password and that is it. I have verified that all else is disabled so there should be nothing else interfering right now. I have disabled the resolver on UnBound and pointed my client directly at 1.0.0.1 to avoid local DNS issues as a challenge.
What am I missing? I know someone is going to say something that makes me feel like a complete idiot. Right now though I just cannot figure it out.
Logged
ab5g
Newbie
Posts: 20
Karma: 1
Re: DNS packets are the only ones that seem to do anything
«
Reply #1 on:
September 17, 2018, 05:12:25 pm »
Starting with some questions
1. I assume you terminate the link. directly on the opnsense box
2. Do you get an ip on the WAN ? Dashboard >> Interfaces widget
3. In the status page, do you have a default route ? It should say default >> gateway ISP IP addr >> MTU >> Interface name etc.
4. Have you installed this in a vm or a physical box ? What is the NIC make ?
5. IF you dont get an IP on the WAN do you need to let you ISP know your MAC?
6. What does Interfaces>> Overview say? Can you post some screenshots
Logged
DIY Tech >>
www.zero-ping.blog
tre4bax
Full Member
Posts: 151
Karma: 4
Re: DNS packets are the only ones that seem to do anything
«
Reply #2 on:
September 17, 2018, 09:37:24 pm »
Hi ab5g
It goes Vodafone -> Dg612 (unlocked) -> OpnSense box.
I reset both to factory then configured the LAN to one port and the WAN to a pppoe connection.
These things are nigh on impossible to debug as the family want to be using the internet all the time! Currently I have to plug it all in and out when I get up for work at 530 in the morning ;-)
Both interfaces work fine and the broadband connects when it is plugged in and shows as down when it is not so all is okay. I can NSlookup from the OpnSense device or any PC on the LAN and it works fine. Nothing else does though. I can tracert to the dns servers from the OpnSense box but only those and nowhere else.
When I look at routes table:
Proto Destination Gateway Flags Use MTU Netif Netif (name)
ipv4 1.0.0.1 212.158.250.36 UGHS 32 1492 pppoe0 wan
ipv4 8.8.8.8 212.158.250.36 UGHS 0 1492 pppoe0 wan
ipv4 90.255.226.54 link#9 UHS 0 16384 lo0
ipv4 127.0.0.1 link#6 UH 0 16384 lo0
ipv4 192.168.0.0/24 link#3 U 1214 1500 em2 lan
ipv4 192.168.0.1 link#3 UHS 0 16384 lo0
ipv4 212.158.250.36 link#9 UH 32 1492 pppoe0 wan
ipv6 ::1 link#6 UH 0 16384 lo0
ipv6 fe80::%em2/64 link#3 U 0 1500 em2 lan
ipv6 fe80::ee8:5cff:fe68:bac2%em2 link#3 UHS 0 16384 lo0
ipv6 fe80::%em3/64 link#4 U 0 1500 em3
ipv6 fe80::ee8:5cff:fe68:bac3%em3 link#4 UHS 0 16384 lo0
ipv6 fe80::%lo0/64 link#6 U 0 16384 lo0
ipv6 fe80::1%lo0 link#6 UHS 0 16384 lo0
ipv6 fe80::%pppoe0/64 link#9 U 0 1492 pppoe0 wan
ipv6 fe80::ee8:5cff:fe68:bac0%pppoe0 link#9 UHS 0 16384 lo0
I have no default route. I DO have the destinations for the DNS servers in going to the gateway 212. Both have pppoe() as their route and they work. 212 is the providers network and where I would expect packets to go. What I don't get is why there is no default route being setup. Interfaces overview is fine two both interfaces are up.
Logged
tre4bax
Full Member
Posts: 151
Karma: 4
Re: DNS packets are the only ones that seem to do anything
«
Reply #3 on:
September 17, 2018, 09:55:11 pm »
This shows the current Routes -> Status better.
Logged
marjohn56
Hero Member
Posts: 1689
Karma: 179
Re: DNS packets are the only ones that seem to do anything
«
Reply #4 on:
September 17, 2018, 09:57:49 pm »
Have a look at your system.log, it's in /var/log
Look for ROUTING: IPv4 entries
You should see something like this:
Sep 14 09:41:18 gateway opnsense: /usr/local/etc/rc.newwanip: ROUTING: entering configure using 'wan'
Sep 14 09:41:18 gateway opnsense: /usr/local/etc/rc.newwanip: ROUTING: IPv4 default gateway set to wan
Sep 14 09:41:18 gateway opnsense: /usr/local/etc/rc.newwanip: ROUTING: IPv6 default gateway set to wan
Sep 14 09:41:18 gateway opnsense: /usr/local/etc/rc.newwanip: ROUTING: setting IPv4 default route to 51.148.*.*
Sep 14 09:41:18 gateway opnsense: /usr/local/etc/rc.newwanip: ROUTING: keeping current default gateway '51.148.*.*
Logged
OPNsense 24.7
-
Qotom Q355G4
- ISP -
Squirrel 1Gbps
.
Team Rebellion Member
- If we've helped you remember to applaud
marjohn56
Hero Member
Posts: 1689
Karma: 179
Re: DNS packets are the only ones that seem to do anything
«
Reply #5 on:
September 17, 2018, 09:58:30 pm »
Where is this 1.0.0.1 coming from?
OK.. DNS server?
«
Last Edit: September 17, 2018, 11:24:32 pm by marjohn56
»
Logged
OPNsense 24.7
-
Qotom Q355G4
- ISP -
Squirrel 1Gbps
.
Team Rebellion Member
- If we've helped you remember to applaud
tre4bax
Full Member
Posts: 151
Karma: 4
Re: DNS packets are the only ones that seem to do anything
«
Reply #6 on:
September 18, 2018, 09:07:59 am »
yeah. 1.0.0.1 is the DNS server. I used 8.8.8.8 to just diversify in case it was the DNS service causing the issues, the second would normally be 1.1.1.1
Logged
Print
Pages: [
1
]
« previous
next »
OPNsense Forum
»
Archive
»
18.7 Legacy Series
»
DNS packets are the only ones that seem to do anything