[SOLVED] Outbound NAT

[candrist]

Brand new to OPNsense. Have been using m0n0wall for 10+ years.

I am trying to setup Outbound NAT for single computer on network, but it doesn't seem to work. I have it setup in hybrid mode and then add the rule for my specific ip and tell it to make it a static port.

Can someone tell me what I am doing wrong?

[slackadelic]

Hmmm if it's outbound NAT you have the source set to WAN... try changing that to LAN.

[slackadelic]

I went back and rechecked what I said, you're right it should work, however I have no true way of testing this right now as I do not utilize custom outbound NAT rules at this time.

[candrist]

Thanks for looking.

[candrist]

I know this is not a feature that most people use. Is there any way to know if how I am setting this up is correct and this is a config issue or a bug in the software?

[candrist]

I ended up switching to Advanced Outbound NAT and defining all the rules for my network manually and it works now.

Hybrid did not work properly for me for some reason.

[weust]

For my PS4 I use Manual (what you end up using) and that worked for me since September last year.
Need the Static Port (no map in m0n0wall) for Type 2.

[slackadelic]

Just to go back over this, there's another forum post I'm on for testing of the libressl features.

I can tell you this much, when I roll back to using openssl, with no UPnP utilized, I did NOT have to do custom outbound NAT rules.

The basic NAT rules worked for me on Xbox.  I've since upgrading my firewall back to using libressl and rebooted.  I will be re-testing this tonight.