Wireguard VPN - No Internet

[gandizzle91]

Hello everyone,

I've already followed several tutorials explaining how to set up a VPN in my home network. Unfortunately, none of them have worked so far, and I'm slowly starting to get frustrated. I do have a suspicion about what might be causing the issue.

I'm using a FritzBox as my router/modem and configured OPNsense as an exposed host. As a result, my WAN IP on OPNsense is an internal IP address from the FritzBox.

My Opnsense is an exposed Host in my FritzBox.

So i can connect via my iphone to the opnsense but i dont get Internet on my iphone i also can see it in the firewall Logs. Additonal here are some screenshots from the configs. Maybe someone can help me.

[vimage22]

At the very least, you need "Endpoint" and "Name" filled in with a value. Also, once the peer is created, I think you have to re-enter "Endpoint Address" and "Endpoint Port" on the Peers config name.

[Patrick M. Hausen]

On the OPNsense side only the IP address of the system connection goes into "AllowedIPs". On the remote system "0.0.0.0/0" goes into "AllowedIPs" to establish a default route into the tunnel.

[gandizzle91]

@Patrick M. Hausen What do you mean by " only the IP address of the system connection goes into "AllowedIPs" ? The Adress of the Firewall itself ? So the lokal IP Adress? Or do you mean my public IP ?

@vimage22 Are you sure? In the tutoral they said that those fields must be blank in the Peer Gererator. Only when you create a manuel peer you should put these information in

[Patrick M. Hausen]

The tunnel address you assign to the "road warrior" device "dialing in".