WG Multi Tunnel GW setup...

[jcditto]

Ok, I've been working at this for about a week now.  I am trying to do a setup were I have 4 WG tunnels and all traffic is routed through those tunnels or not at all, if the tunnels are down.  I have the basic connectivity working, but only if I just allow all on the traffic.  Once I put in a "Route to VPN only/Kill Switch" rule set, I cannot route on any client.  The good news is, even with allow all on, traffic seems to stick to the tunnels, but since I can't force it there or nothing, I can't be sure it will stay that way.  We could fall off the VPN at any point and not notice.  I dont' know what you need or want to see on the setup, just let me know and I can provide the info.  I don't want to toss info on here without a request of it, as that may confuse the issue.

Summary of Goals:
4 VPN tunnels setup in a group, all T1, just aggregating for speed
Ability to force traffic through that GW setup and if no VPN tunnel, block till working again.

Currently:
Tunnels are in, working and flowing fine however, if I disable them traffic just falls back to the open WAN connection, instead of failing
I have build a tunnel rule and a killswitch rule, but when enabled and allow all is off, no routing works.