WireGuard (NordLynx) Interface/Device Not Recognised on Zenarmor

[Scow92]

Hi - complete newbie here!

I have configured WireGuard VPN (NordLynx) using multiple guides I found on various forums. VPN works fine, the one issue I have is that Zenarmor does not recognise the interface under devices. Currently all the traffic that is routed over the VPN is displayed as 'Device (none)'.

Is this expected behaviour? I have another WireGuard VPN tunnel configured to enable remote access into the network, this is captured fine in Zenarmor. The only difference I can see is that under VPN > WireGuard > Status this interface has a 'Name', the NordLynx VPN does not.

Any help would be greatly appreciated!

Thanks.

[sy]

Hi,

Did you protect the Nordlynx interface on Zenarmor? If so, can you see any traffic from this interface in the Reports - Connections - Interfaces & VLAN chart? Lastly, is this interface's IP block assigned to a local usage block?

[Scow92]

Interface (wg0) is protected, security zone is set to custom (vpn).

I can see traffic on wg0 under Interfaces & Vlans. If I filter to see live sessions > connections, everything is showing as Device (none) and src hostname is the tunnel IP provided by NordVPN.

Interface IP is in the 10.0.0.0/8 block.

I used this guide to set up the VPN:

https://docs.opnsense.org/manual/how-tos/wireguard-selective-routing.html