NewInstallation-Webconsole error-503 Service Unavailable-Unbound DNS

[partha]

I'm completely new to OPNSENSE - just trying it out on old hardware.

Overview :
Fresh installation OK
Multi-WAN setup OK
Firmware update OK
Other basic settings OK
VPN setup OK
Unbound DNS - OK
--- so far so good---
Unbound DNS - added Adguard blocklist
GUI crash - BUT otherwise the system is still working OK
GUI error - 503 Service Unavailable


Can anybody help with this? or else I have to perform a Reset to factory defaults and reload my last good configuration?

[partha]

some more info - if this helps :

************************************************************************************************
root@PPDAS-Firewall:~ # sudo configctl service status unbound
unbound is not running.



root@PPDAS-Firewall:~ # service unbound status
unbound is not running.
root@PPDAS-Firewall:~ # service unbound start
Cannot 'start' unbound. Set unbound_enable to YES in /etc/rc.conf or use 'onestart' instead of 'star                             t'.
root@PPDAS-Firewall:~ # sudo service unbound start
Cannot 'start' unbound. Set unbound_enable to YES in /etc/rc.conf or use 'onestart' instead of 'start'.
root@PPDAS-Firewall:~ # sudo service unbound onestart
Obtaining a trust anchor...
Starting unbound.
[1740771629] unbound[46595:0] error: bind: address already in use
[1740771629] unbound[46595:0] fatal error: could not open ports
/usr/local/etc/rc.d/unbound: WARNING: failed to start unbound



root@PPDAS-Firewall:~ # service webgui status
webgui does not exist in /etc/rc.d or the local startup
directories (/usr/local/etc/rc.d), or is not executable
root@PPDAS-Firewall:~ # sudo service webgui status
webgui does not exist in /etc/rc.d or the local startup
directories (/usr/local/etc/rc.d), or is not executable
************************************************************************************************

[newsense]

You restart the webgui like this:

Code Select Expand

configctl webgui restart

[partha]

@newsense : Thank you for your response but no luck here...
From the Serial console, I can see that there is a new firmware available...
I'm Currently running OPNsense 25.1.1 (amd64) at Sat Mar  1 03:00:49 IST 2025
The latest one is 25.1.2 >> released yesterday 2025-02-28
Trying to update from the console ...
Hope it will solve the issue...
Will update you on the outcome...
Thanks again.

[partha]

Hi,

Problem solved after firmware upgrade to latest version    25.1.2

Thank you