New install, menu not showing up in UI

[jerryd]

Tried to install Zenarmor on 2 different machines tonight..

Looks like both packages install correctly, however the zenarmor tab does not show up in the menu..

Any ideas?

Thanks

Jerry

[IHK]

Hi Jerry,

The issue of the Zenarmor tab not appearing in the menu can be caused by a few different reasons. Here are some steps you can try to resolve the problem:

First, ensure that your OPNsense installation is fully up to date. You can check for updates by navigating to System > Firmware > Updates in the OPNsense interface. If updates are available, install them and reboot your system afterward.

Sometimes, browser cache or configuration issues can cause problems like this. Clear your browser cache and refresh the page using CTRL + F5. Alternatively, try accessing the interface using a different browser or by using incognito/private mode.

If you are using a "Dark" theme in the OPNsense interface, it may cause compatibility issues that prevent the Zenarmor tab from appearing. Switch to the default theme and check again. You can change the theme by going to System > Settings > General > Theme.

Finally, verify that Zenarmor is properly installed. Go to System > Firmware > Plugins in the OPNsense interface and check if Zenarmor is listed there. If it is listed but the tab is still missing, try uninstalling and reinstalling Zenarmor.

If the issue persists after following these steps, feel free to share more details.

[jerryd]

First tests, updates found nothing to update as it was done prior.

Firefox and Edge both did not show the ZA tab

I then removed both ZA packages, and then the Dark theme.

Rebooted, re-installed the ZA packages and then the tab showed up!

Same for both boxes.

I did not go beyond looking at the setup, as I need some sleep tonight!

Thanks