Wireless AP mode, no WPA

[none]

Hi,

I have a working run0 interface configured as AP. I can connect to it, but it always has no WPA security.

I checked all options for WPA, using AES and defined a pre-shared key. But the network created is always an open one, asks for no key at all.

Is there the desired behavior? I checked all twice, all is left is installing any plugin needed (if any) or to understand it won't work. I tried using different WIFI nics, all the same.

If anyone can help me, thanks :)

none

[none]

Hi,

small update. I saw some messages on the dmesg:

Code Select Expand

run0 on uhub5
run0: <Ralink 802.11 n WLAN, class 0/0, rev 2.00/1.01, addr 1> on usbus0
run0: MAC/BBP RT5390 (rev 0x0502), RF RT5370 (MIMO 1T1R), address xx
run0: [HT] Enabling 802.11n
lo0: link state changed to UP
pflog0: permanently promiscuous mode enabled
ieee80211_load_module: load the wlan_amrr module by hand for now.
wlan0: Ethernet address: xx
wlan0: changing name to 'run0_wlan1'
run0: firmware RT3071 ver. 0.33 loaded
run0_wlan1: link state changed to UP
ieee80211_load_module: load the wlan_ccmp module by hand for now.
run0_wlan1: link state changed to DOWN
re0: link state changed to UP
run0_wlan1: link state changed to UP
ieee80211_load_module: load the wlan_ccmp module by hand for now.
run0_wlan1: link state changed to DOWN
run0_wlan1: link state changed to UP
ieee80211_load_module: load the wlan_ccmp module by hand for now.
run0_wlan1: link state changed to DOWN
run0_wlan1: link state changed to UP
ieee80211_load_module: load the wlan_ccmp module by hand for now.
run0_wlan1: link state changed to DOWN
run0_wlan1: link state changed to UP
ieee80211_load_module: load the wlan_ccmp module by hand for now.
run0_wlan1: link state changed to DOWN

And then I updated /boot/loader.conf.local by adding wlan_ccmp and at least WAN as Wifi client works. Now I will add wlan_amrr and try again when possible.

none