Author Topic: Newbie with a hardware question (Read 363 times)

bebemaOs · « **on:** October 22, 2024, 04:48:07 am »

Folks
I am a newbie here trying to understand how to setup my OS . I installed it on a Lenovo M90n box with 2x 1G ports , I used 1 for the WAN and 1 fo the Inside segment, but i have an accompanying IoT box with two more ports and i need to see if i can use them. When i look at the dash they say "Unassigned Interface"

Is there a way to bring these up and assign them to the regular interfaces section so that i can use them, If so can you please send me where i need to go to get that info

bartjsmit · « **Reply #1 on:** October 22, 2024, 07:35:18 am »

Welcome! Check out Interfaces: Assignments, click + Assign new interface

bebemaOs · « **Reply #2 on:** October 23, 2024, 02:14:50 am »

Mmm, i dont have any + on the interface assignments options. I only have the interfaces i assigned for the WAN and one for the LAN

bartjsmit · « **Reply #3 on:** October 23, 2024, 07:52:54 am »

Do they show in the console? Pick option 1

Author Topic: Newbie with a hardware question (Read 363 times)

bebemaOs

Newbie with a hardware question

bartjsmit

Re: Newbie with a hardware question

bebemaOs

Re: Newbie with a hardware question

bartjsmit

Re: Newbie with a hardware question