config changes apply only after service disable/enable

[cj_duke]

Hello everyone,

with my opnsense instance I observe the following behaviour:

- Wireguard interface after reboot has the ipv4 address missing. I have to disable and reenable WG for the interface to bring up both ipv4 and ipv6 address.

- Changing the WG config (adding peer) does add the peer, but the peer can not connect (handshake not complete). I have to disable and reenable WG to accept the new config/peer.

- I did setup (new instance - testing environment) nginx with upstream server. Some behaviour as on running instance, the setup/config for nginx was only accepted as I disabled and reenabled the service.

Is this normal behaviour? Which point I am missing with configuring these services?