arprequest_internal: cannot find matching address - Clean install

[glen4cindy]

I'm a brand new first time OPNsense user running a fresh install of OPNsense using a NUC with 4 network ports.

I did a clean install and then used the guide at Zenarmor to configure it as a transparent filtering bridge.

The message above is showing on the display I have connected to the NUC and is also visible in System > Log Files > General.

Nothing is configured other than "pass all" rules on the WAN, LAN, and Bridge interfaces. I used a static IP on the bridge to manage the device as outlined in the directions.

Other then this constant message scrolling on the display the bridge seems to be functioning properly.

I've done a search here and went through the 10 results that pulled up. I'm not using Suricata nor does a reboot stop this message from coming up as it did for some in the results.

Suggestions on how to fix this would be appreciated.

Thanks in advance.

[glen4cindy]

I'm reaching out again for support with this issue.

I'm still facing this issue and I've not been able to find anything out though I've done quite a bit of searching.

Do I need to provide more information?

Thanks in advance.