Broadcom BCM57766 if_bge no longer works.

[judd]

I have 2 Broadcom ethernet cards that worked fine up until the 24 release.

On 23.7.10_1 I see in dmesg:

bge0: <Broadcom unknown BCM57766, ASIC rev. 0x57766001> mem 0xf4110000-0xf411ffff,0xf4100000-0xf410ffff irq 19 at device 0.0 on pci3
bge0: CHIP ID 0x57766001; ASIC REV 0x57766; CHIP REV 0x577660; PCI-E
miibus0: <MII bus> on bge0
brgphy0: <BCM57765 1000BASE-T media interface> PHY 1 on miibus0
brgphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-master, 1000baseT-FDX, 1000baseT-FDX-master, auto, auto-flow
bge0: Using defaults for TSO: 65518/35/2048
bge0: Ethernet address: xx:xx...


On 24.1 the system doesn't seem to detect the card at all.

# kldload /boot/kernel/if_bge.ko
module_register: cannot register pci/bge from if_bge.ko: already loaded from kernel
Module pci/bge failed to register: 17
module_register: cannot register bge/miibus from if_bge.ko: already loaded from kernel
Module pci/miibus failed to register: 17
kldload: can't load /boot/kernel/if_bge.ko: module already loaded or in kernel