traffic shaper + multiwan

[keropiko]

Hello all,

i have Opnsense 23.7.8_1 installed and trying to figure out how to setup traffic shaper.
I have followed every guide in this forum and on the official guides without result.

I have a multiwan setup with a vdsl and a 4g lte connection.
In the shaper settings i have setup pipes for  dsl up & down and 4g up & down.
in the rules section i have setup a rule without destination and source, only with direction (in or out)
one for each pipe. One for the upload pipe of each connection and one for the download pipe of each connection.

The problem is that after a lot of spending hours and testing, i noticed that even if i have policy routing for a device to use a specific gateway (for example instead of the primary dsl to use the 4g) instead of using the shaper rule for the 4g connection, it respects the rule for the vdsl connection (default wan connection/gateway for opnsense) which has a lower upload.

Even if i put the non-default gateway/interface rule higher, the shaper does not respect the rule.

From what i undestand, the shaper respects from the multiwan, as gateway, the default (active) wan?

Why don't the devices with the policy routing, use the shaper for the interface configured istead?

I also have shared forwarding enabled.

**** This happens to the devices to which i connect from remote (NAT- port forward), from internal LAN the shaper works correctly.

thank you