[23.7.8] wireguard ip assignment

[cj_duke]

Hello everyone,

I updated to 23.7.8 and wireguard is showing a strange behavior. It has an assigned ipv4 and ipv6 address. The webgui shows both, in the shell only ipv4.

I also cannot add a gateway (ipv6) and therefore no routing, because opnsense is complaining not having a ipv6 address assigned to the interface (wg1).

Deleting the ip and reassigning did not help at all.

[franco]

Hi,

Same as https://forum.opnsense.org/index.php?topic=36893.0


Cheers,
Franco

[cj_duke]

Thanks franco!

Works again as intended

[franco]

Good, this will be hotfixed later today.


Thanks,
Franco