Multi Wan with Starlink

[Sirbatchu]

Hi after some advice or assistance. We have 2 Wan ports configured on the OpnFSense box. WAN is our primary , priority set to 254, then Starlink set to 255. I have Starlink set as passthrough. And gateway is showing as online. As I had to add this in a very particular manner.

Has anyone managed to get this to work, with failover and ornload balancing. Most importantly getting their Lan to speak out on that network. As I have managed to get to a point where I could get the Gateway to send out traffic, but nothing goes out.

Any assistance would be much appreciated!

Regards

Matt

[lfirewall1243]

Have you read the docs?
Sounds like a normal Multi-WAN setup (failover or load balancing)

[Sirbatchu]

Hi thanks for the reply, yes I set this up against the Failover Docs without any luck, I think the issue I have is more the Routing of it, as to how does the Lan know where to route traffic to the gateway.

[lilsense]

your information is quite vague at best...
 if you followed this doc, https://docs.opnsense.org/manual/how-tos/multiwan.html
then you should be good to go... I am not sure however, about your priority...