Interface Statistics - Wireguard

[chris32]

Upgraded to 23.1_6 and I'm seeing "Errors In" slowly ticking up for my Wireguard VPN interface in the Interface Statistics dashboard widget when Wireguard clients are connected.

I have not reverted to Wireguard go as Wireguard kmod included in 23.1 is working perfectly. I’m also not seeing any errors on my WAN interface.

Same setup was running fine with 22.7.

Any ideas how to investigate further? I did see a older forum post about changing Keepalive Intervals but this made no difference.

Could it be that the Interface Statistics dashboard widget also needs update to work with Wireguard kmod?

[tiermutter]

I also can see a few errors, but I never had a look to interface statistics before:

            Packets In    Packets Out    Bytes In    Bytes Out    Errors In    Errors Out    Collisions
WG0    3.756.320    5.075.687    3.20 GB    5.31 GB            218             2                    0

What I found for kmod (used go before) is that CPU usage (E3845) goes up to 80%+ when transmitting (large) files via SMB, I cannot remember that I had this with WG go.