Wireguard "Group" missing in firewall rules with os-wireguard

[Flappie]

Hi,

Installed Opnsense 23.1 and imported my config from version 22.7.1
I installed "wireguard" (not wireguard-go as in the previous 22.7).

Howver, i'm missing the "Wireguard group" under firewall rules.
This group was still there with version 22.7.

So, all my WireGuard clients are connected however they can't access anything since al firewall rules are missing.

[Flappie]

FYI, removing os-wireguard and reinstalling os-wireguard-go brings back the group with the rules.

[chemlud]

Hi!

That sounds strange, as the kernel version of WG is supposed to work...

[tiermutter]

Everything's fine here. Updated from 22.7.11(_1) and the WG group still exists without any changes regarding the rules.

[RedVortex]

FYI, removing os-wireguard and reinstalling os-wireguard-go brings back the group with the rules.

I upgraded to 23.1, I did not reinstall from zero as you did and the group still is present. However, maybe this means something was handled by the wg-go plugin scripts when it is installed to create the group in the rules and maybe this isn't present anymore with the kmod. Just a theory...

[mimugmail]

Just edit one firewall rule and save again, then it will be there.

[Flappie]

Just edit one firewall rule and save again, then it will be there.

How to edit when the rules/group are not visible?

[tiermutter]

Maybe you should edit any rule on any interface?!

[mimugmail]

Just edit one firewall rule and save again, then it will be there.

How to edit when the rules/group are not visible?

Just edit an existing rule and after save Group will pop up

[yeraycito]

Opnsense 23.1 fresh install - no restore backup config

all correct