Wireguard multiple endpoints - adjacent IP addresses

[kysave]

Hello all!

I’m configuring Wireguard using the following How-To and everything works just fine so far.
https://docs.opnsense.org/manual/how-tos/wireguard-selective-routing.html

There is only one thing I’m not sure about when configuring multiple endpoints which have adjacent IP addresses, e.g.

10.0.0.20/32 (so I’d have to choose 10.0.0.19 as the associated gateway in advanced mode)
10.0.0.21/32
10.0.0.22/32 etc.

Am I correct in assuming that choosing 10.0.0.20 as the gateway IP address for the second endpoint would lead to conflicts? Is it then ok to take e.g. 10.0.0.17, …18 IP’s?

Thanks!

[Greelan]

Yes - see the note in that section of the how-to

[kysave]

Indeed, thank you! I don't know how I managed to miss it.