Ipv6 and Zen

[walkerx]

I currently use Ipv6 on Zen and and whenever they have maintenance and connection is severed, when it comes back up the IPv6 does not work, even though radvd and dhcpd6 are both showing as running. I can recycle radvd but still no IPv6 connection and if I then try recycling dhcpd6 it then shows that it's stopped.

Dropping the connection and then reconnecting doesn't always solve the problem and in the end I have perform a full reboot of the opnsense box.

If I switched to manual dhcpv6 settings and configured opnsense to hand out ip's to clients will I have the same issues, if not how hard is it to configure the ipv6 settings for this so all network devices can get an ipv6 address