Mysterious "sendto: Permission denied"

[GaardenZwerch]

Hi,
I have a weird behaviour somehow related to source NAT an route-based IPsec tunnels:

Networks A and B are behind an OPNsense Box (22.1) and should access to resources through a Tunnel.

Network B should be NATted as Network A for this. The NAT itself works.

• I can see the packets leaving through ipsec<X>
• I can see that the source has been correctly replaced with an address from Network A
• Packets really originating from Network A reach the other side
• when I try to generate traffic on the firewall itself (*), i get sendto: Permission denied
   errors
• when I temporarily pfctl -d packets reach the other side
• when I remove the outgoing NAT rule, packets reach the other side, with the undesired source addess

I can't see anything related in pflog, even if I enable logging in the 'permit' rule.

How do I figure out what causes the 'permission denied'? IDS/IPS is disabled.

Thanks a lot,
Frank

(*) either using ping -S Network-A-Addres, or using nc -vz -s

[mimugmail]

Firewall : Settings : Advanced : Disable Force Gateway ticked?

[GaardenZwerch]

Hello,
yes I tried both with and without this option.
Any other ideas?
Thanks,

[mimugmail]

Hm, I always was under the impression that SNAT doesn't work with route-based tunnels .. was this also working with 21.7?

https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=248474

[GaardenZwerch]

Hi,
no this didn't work with earlier releases AFAIK.
I remember trying to to SNAT before route-based IPSec before on a different site, but I ended up with a different solution as I couldn't get it to work.

[GaardenZwerch]

Hm, I always was under the impression that SNAT doesn't work with route-based tunnels .. was this also working with 21.7?

https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=248474

Hi Michael,
does this make sense:

Code: [Select]

sysctl net.enc.out.ipsec_filter_mask=0
sysctl net.enc.in.ipsec_filter_mask=0
sysctl net.enc.out.ipsec_bpf_mask=0
sysctl net.enc.in.ipsec_bpf_mask=0
sysctl net.inet.ipsec.filtertunnel=1
sysctl net.inet.ipsec6.filtertunnel=1
(found here https://www.reddit.com/r/OPNsenseFirewall/comments/ts86eh/ipsec_gateway_as_upstream_gateway/ )

[mimugmail]

I wrote about these values in the official FreeBSD bugtracker issue and was warned that when you mix routebased and legacy, one of them will break :/

[Sieg]

Hi,
I have a weird behaviour somehow related to source NAT an route-based IPsec tunnels:
..

Maybe a block/reject rule at last position with Direction=out?