Wireguard road warrior (followed default guide) - all work but cant ping clients

[Greelan]

Really? That sounds odd to me. By the same logic, just using 0.0.0.0/0 as Allowed IPs should have the same routing priority. I'm pretty sure I have observed this behaviour - ie if I connect to an external VPN while on my LAN, I can't access my LAN if all traffic is configured to go over the tunnel

[allebone]

Its ios specific I believe. I have tested this at a nearby location that has the same lan range as my local lan network. Without this setup I cant access anything on the 192.168.2.0 range as it sends it local to the coffee shop. Adding in the additional range in allowed ips sends everything over the tunnel except the default gateway of the coffee shop which is 192.168.2.1. I can make a video from my phone on Saturday showing this working if you want as I can go past but not before then unfortunately.

[Greelan]

I don't need a video. My observation was on an iPhone too [emoji2369]. I can do some further testing later