Rebooting message in firmware update

[tong2x]

how to clear the update log?
A message system is rebooting always show...

have tried ti more than 5 times, it goes to the main screen but going to update will show the same...

I also tried rebooting more than 4 time the system but still the same...

some how it detect a marker or sort that the system need to reboot
(this was after the OPNsense 20.7.4-amd64 update...
how to solve?

[mkwerth]

I had the same issue and also could not login via ssh (the authentication no longer worked) to force a reboot from the command line.

As I also had no access to the console, the only solution was to power cycle the firewall. It then rebooted and everything worked again.

However, I have to say, this is not how an upgrade should go. 

[Paweł]

I had the same issue, but ssh is working...

Keep healthy
Paweł

[tong2x]

I had the same issue and also could not login via ssh (the authentication no longer worked) to force a reboot from the command line.

As I also had no access to the console, the only solution was to power cycle the firewall. It then rebooted and everything worked again.

However, I have to say, this is not how an upgrade should go. 

I also have console, tried rebooting via console at via the web gui several times but no effect

by powering off? the issue was gone? have not done that yet, will try that