Does opnsense not let you put vlan's into ospf?

[loganx1121]

I have 2 port LAG going from the fw to a cisco switch that has 6 Vlans running over it. All the .1's for the Vlans are on the firewall. I can't seem to get the firewall to advertise any of the Vlan networks over ospf.

I have a L3 LAG running from the firewall to the cisco switch, and that advertises fine. Just wondering what the deal is.

[mimugmail]

Did you check interface and network tabs in OSPF config? Everything fine? Config?

[loganx1121]

Got it to work by setting network type to "Point to multipoint"

[loganx1121]

Actually if you do point to multipoint, you only get a route for the .1 of the vlan that lives on the firewall, so I went with broadcast which adds the entire /24 to the ospf routing table

[mimugmail]

NBMA should be used in usual networks

[Patrick M. Hausen]

NBMA should be used in usual networks

NBMA for Ethernets? Could you explain?

Thanks,
Patrick

[mimugmail]

No, because it's nonsense, I mixed this .. sorry.