[Solved] Upgrade to 20.7.2 WAN speed down to 10%

[Taomyn]

How can I revert back to v20.7.1?


Upgraded to v20.7.2 and now my WAN speed is down to 50MBit instead of the usual 500MBit - the connection is via a PPPoE. ISP confirms everything ok there side and upgrade is only change. Have also rebooted twice.

[banym]

Can't reproduce that. Here 100/40Mbit still full Performance.

[Mondmann]

Also here everything is OK after the update to 20.7.2 with
250/40Mbit line and full power.
just tested with: h**s://speedof.me/

[hushcoden]

Also here no issues...

[oxydius]

Try booting 20.7 with a USB key and run it in LiveCD mode after importing your config to make sure it's the update (or not).

With 20.7.2 I'm getting 855/764 Mbit with about 40% CPU load.

[Taomyn]

Thanks everyone, woke up this morning to an email from my ISP saying "we discovered a _flaw_ (their word) in your configuration and corrected it". I checked the logs and my connection did get reset during the night.


Did my speed check again and I'm back to normal now.

[nikkon]

after updating to OPNsense 20.7.2-amd64
my wan is constantly disconnecting!
Interface is an intel em0
connection is a DHCP
any clue? or hotfix?

[mimugmail]

Logs?

[nikkon]

not really because in my case, it always ends up with a reboot -> 0 logs
hope to catch it something next time

[mimugmail]

Then you surely have something on the console with a backtrace / stacktrace

[yeraycito]

Updated to 20.7.2 and no problem
Interface intel igb0