Wireguard not populating Peer in wg0.conf from GUI on fresh 20.7 install

[dancwilliams]

Hello,

I have a fresh install of 20.7 and am setting up Wireguard.  What I am noticing is that when I configure an endpoint in the GUI the config does not seem to be saved to the wg0.conf file.  I have tried removing the plugin and putting it back in, deleting the setting and starting over, etc. with no luck.

The Interface config is populated properly in the wg0.conf file, just not the Peer config.

When I go into the CLI and add the Peer config by hand to the wg0.conf file everything works fine.  I am able to connect from my phone without issue.  But when I go into the GUI and click save within the Wireguard area it overwrites the conf file and removes the Peer config, even though it is present within the GUI.

Any assistance would be greatly appreciated.  I am new to OPNsense but have been using Wireguard for a while.  Just trying to figure out what I am missing.

Thanks!

[Patrick M. Hausen]

You need to check the peer as active in the local endpoint tab.

[dancwilliams]

Thank you so much! I knew I had to be looking over something obvious. I need to look at the documentation to see how I missed that.

Thanks again!