Replace installation’s SSD

Started by jonm, June 10, 2020, 02:42:46 PM

Previous topic - Next topic
I need to replace the SSD that Opnsense is installed on in my system. Just wondering if there's an approved/best way to do this. I was planning to boot into Linux from a USB stick and use dd to duplicate the old disk to the new. Any reason why this shouldn't work?

Thanks,

Jon.

Hi,
I've never had any problem cloning a hard drive with a hardware clone device. It should work!


Enviado desde mi iPhone utilizando Tapatalk

Why not just

1) Full backup of config
2) Fresh install on new ssd
3) Restore config?

June 11, 2020, 08:46:12 AM #3 Last Edit: June 11, 2020, 08:48:18 AM by iMx
Quote from: 5SpeedFun on June 10, 2020, 03:31:05 PM
Why not just

1) Full backup of config
2) Fresh install on new ssd
3) Restore config?

Not just me then? :p

Although I guess if you have any /boot/loader.conf.local customisations, these might not (wont?) make it...

Thanks all, maybe I'll try the backup/fresh install/restore approach.