Author Topic: Traffic shaper stops working when adding multiple pppoe (Read 6355 times)

stevovo · « **on:** November 15, 2015, 06:43:39 am »

Hi,

I'm using version 15.7.17-amd64.

I did a clean install, set up my pppoe connection and put in a few traffic shaper rules. The rules work because I can see the one computer on the LAN speed drop as soon as I start doing speed tests on another computer.

The moment I add another pppoe connection, the traffic shaping no longer works.

I've restarted the firewall state rules and even rebooted but it only starts working again after removing the second pppoe

franco · « **Reply #1 on:** November 24, 2015, 11:10:03 pm »

Does the second PPPoE link come up ok? Is it usable? We've had reports of half-working scenarios, e.g. https://forum.opnsense.org/index.php?topic=1711.0

stevovo · « **Reply #2 on:** November 25, 2015, 08:15:13 pm »

Both ppp connections are from the same ISP. They both get a unique IP but under Status -> Gateways they have the same gateway?

I can still route connections out through either one using firewall rules though.

Could this be the issue?

Author Topic: Traffic shaper stops working when adding multiple pppoe (Read 6355 times)

stevovo

Traffic shaper stops working when adding multiple pppoe

franco

Re: Traffic shaper stops working when adding multiple pppoe

stevovo

Re: Traffic shaper stops working when adding multiple pppoe