Home
Help
Search
Login
Register
OPNsense Forum
»
English Forums
»
General Discussion
»
Web interface problem
« previous
next »
Print
Pages: [
1
]
Author
Topic: Web interface problem (Read 11472 times)
gflasins
Newbie
Posts: 7
Karma: 1
Web interface problem
«
on:
September 29, 2015, 04:09:53 pm »
I updated two opnsense devices using the built-in update from the console and on one of them I lost the ability to connect to the web interface. They are both running 15.7.14 and have very similar configurations. Both web interfaces were accessible before the updates. Can someone tell me some troubleshooting steps? I'm not a big linux user and I'm kind of at a loss for what to do beyond the obvious "select option 11 to restart the web service" step. Thanks.
Logged
franco
Administrator
Hero Member
Posts: 17660
Karma: 1611
Re: Web interface problem
«
Reply #1 on:
September 30, 2015, 08:10:01 am »
On the "broken" one choose (
to go to the shell and run:
# opnsense-update -pf
Does that bring back the GUI? May have to try (11) afterwards, too.
Logged
gflasins
Newbie
Posts: 7
Karma: 1
Re: Web interface problem
«
Reply #2 on:
September 30, 2015, 04:03:33 pm »
That doesn't seem to have fixed the problem. However, I was able to access the web interface through the LAN connection today since I'm on site. Still can't get to it from anything on the WAN, though.
Logged
franco
Administrator
Hero Member
Posts: 17660
Karma: 1611
Re: Web interface problem
«
Reply #3 on:
October 02, 2015, 07:43:37 am »
This sounds odd. It may just be a configuration issue and I am assuming a reboot of the offending firewall did not help?
Logged
gflasins
Newbie
Posts: 7
Karma: 1
Re: Web interface problem
«
Reply #4 on:
October 02, 2015, 03:52:49 pm »
No. I've tried rebooting. I've done a side-by-side comparison of the two routers to find any discrepancies (other than the obvious like IP address) and I don't see anything that would be causing this. I had a colleague look at it, too. I even asked around to see if there were any networking changes made. Nothing. We're baffled.
Logged
franco
Administrator
Hero Member
Posts: 17660
Karma: 1611
Re: Web interface problem
«
Reply #5 on:
October 03, 2015, 05:26:34 pm »
So am I. How should we proceed? A checklist:
o The webserver is running... # pgrep lighttpd
o The webserver is reachable via at least one interface.
o Firewall logs show no block rule for GUI access via WAN.
o If there is traffic being blocked, click symbol in first column to reveal which rule blocks.
o Port and NAT for GUI active? HTTP or HTTPS?
o Is WAN an internal network? IPv4 or IPv6. Bogons and private stuff being blocked by default?
Logged
gflasins
Newbie
Posts: 7
Karma: 1
Re: Web interface problem
«
Reply #6 on:
October 05, 2015, 08:18:15 pm »
Okay, I've narrowed this down a bit. For some reason traffic is blocked from the WAN that the router is connected to. That makes no sense as the only change that occurred was an update of the Opnsense router. Still can't find a local firewall reason for that, but I'm continuing to troubleshoot. Thanks for all the input!
Logged
DervMan
Newbie
Posts: 2
Karma: 0
Re: Web interface problem
«
Reply #7 on:
October 08, 2015, 11:31:32 pm »
I'm having the same problem...... Watching this thread with interest.
Logged
gflasins
Newbie
Posts: 7
Karma: 1
Re: Web interface problem
«
Reply #8 on:
October 09, 2015, 04:35:22 pm »
o The webserver is running... # pgrep lighttpd
- This returns a number. Also, it appears to be running anyway since it's accessible from the LAN.
o The webserver is reachable via at least one interface.
- Accessible from LAN.
o Firewall logs show no block rule for GUI access via WAN.
- Can't find any block rule.
o If there is traffic being blocked, click symbol in first column to reveal which rule blocks.
o Port and NAT for GUI active? HTTP or HTTPS?
- Appears to be the case? Both HTTP and HTTPS.
o Is WAN an internal network? IPv4 or IPv6. Bogons and private stuff being blocked by default?
- WAN is a public network. IPv4. Web interface is not accessible from other IPs on the WAN.
- I know I've seen the bogon option before, but I'm not finding it again. I feel like it's buried at the bottom of another config. page. Someone remind me?
Logged
franco
Administrator
Hero Member
Posts: 17660
Karma: 1611
Re: Web interface problem
«
Reply #9 on:
October 10, 2015, 04:02:15 pm »
Most items pass the check list, still a bit weird. Bogon and private options are under Interfaces -> WAN at the bottom, but I am guessing they won't help in this case.
Does pinging the WAN IP work from the outside?
Logged
franco
Administrator
Hero Member
Posts: 17660
Karma: 1611
Re: Web interface problem
«
Reply #10 on:
October 11, 2015, 01:48:11 pm »
I just realised pinging requires enabling ICMP on WAN.
Logged
gflasins
Newbie
Posts: 7
Karma: 1
Re: Web interface problem
«
Reply #11 on:
October 12, 2015, 04:00:55 pm »
"Block private networks" and "block bogon networks" are both unchecked. (This is true on both routers.)
Logged
franco
Administrator
Hero Member
Posts: 17660
Karma: 1611
Re: Web interface problem
«
Reply #12 on:
October 13, 2015, 07:19:29 am »
There's something obvious we're both missing, either es subtlety in the config that is different or the network setup itself. Can you please elaborate?
Logged
gflasins
Newbie
Posts: 7
Karma: 1
Re: Web interface problem
«
Reply #13 on:
October 19, 2015, 04:18:26 pm »
I'd elaborate if I could. I'm kind of getting to the point of giving up since it's not effecting functionality, especially since several technicians have looked at this already.
Logged
franco
Administrator
Hero Member
Posts: 17660
Karma: 1611
Re: Web interface problem
«
Reply #14 on:
October 20, 2015, 06:05:55 pm »
Is the box still active? Have you tried to restore the box with the other box's config? Have you tried to swap place to see if the box or the network setup is the root cause? So many things to try. Alternatively, Deciso offers support if this is still of (business) interest.
Logged
Print
Pages: [
1
]
« previous
next »
OPNsense Forum
»
English Forums
»
General Discussion
»
Web interface problem