Static Routing Question

[davehg]

Scenario: Comcast is my IP and because I use the home security product, I am locked to their modem. I set up my network in the available DMZ. I have OPNsense 19 as my gateway. Prior to this I used Meraki. My primary network runs in the 192.168.1.0/24 range. I also have a home lab. This is set up in the 192.168.2.0/24 range. Traffic is passed via static routing between the 2 ranges with a gateway router at 192.168.1.2. All of this worked flawlessly with the Meraki.

In OPNsense
- I have set up the gateway to the Lab network 192.168.2.0/24 in the 192.168.1.0/24 range (screenshot added)
- Created a static route to tell OPNsense what to do with traffic addressed to the Lab network IP range. (screenshot added)
- Created a firewall rule to allow traffic from the 192.168.2.0/24 range to traverse the firewall (screenshots added)

NEW: The switch in the 192.168.1.0/24 range is a Ubiqiti 16 port w/ POE, and the gateway between the 192.168.1.0 and 192.168.2.0/24 ranges is a Cisco (Linksys) RX1000

Traffic between 192.168.1.0/24 and 192.168.2.0/24 works fine.What I cannot get to work is accessing the internet from 192.168.2.0/24. Can someone review the screenshots and point out something I am doing wrong? I would be very appreciative.

EDITED: Added the additional hardware details marked with "NEW"

[mark.migliorini]

Hi,


I'm experiencing the same problem,
I set the gateways to internal sub net (switch core) sets reach all the vlan behind this
openvpn client function and reaches them.
but from these I can't access the internet, even if the firewall log says allowed traffic.

can it be a vmware vswitch problem?