no wiregaurd interface to select

[memnoch_proxy]

I have installed the wireguard and wireguard-go modules. I'm using OPNsense 23.7. I have created and Local and Endpoint configuration. However, under Interfaces I only have an OpenVPN interface free and no Wireguard interface listed. This system was using OpenVPN previusly back in versions 14-20, but I do not want to operate an OpenVPN peer anymore.

How do I proceed to get WG working on this system?

[newsense]

Start by installing or upgrading to 24.1

[memnoch_proxy]

I don't mind upgrading to 24.1. Do I correctly infer that there are WG related bugs in v 23?

[newsense]

A lot of changes, and 24.1 is the currently supported one.

You can read all about it in the Announcements board

[jmcgee]

    OPNsense 24.1_1-amd64

[jmcgee]

I have same problem, I suspect it is because I can't get the Zerotier Network enabled.  Can you ?

[memnoch_proxy]

@jmgee sorry, I might get a chance to check on ZT after I focus on present conundrum.

[memnoch_proxy]

I have updated system to OPNsense 24.1.5_3-amd64.

I can see packets leave my cloud host over the private network (10.4.6.0/23) but I do not see them in OPNsense when I tcpdump wg1. I have opened the firewall for the WG port. My firewall is behind a Comcast modem and it has a 10.1.10 address. Could I be seeing these problems because the Comcast modem is blocking my WG port?