I killed NEW Opensense - How to FIX

[jhinkle]

I purchased a new Protectli 2420 with OpnSense installed.  Since my home network is currently a 192.168.1.xx network I wanted to change the LAN IP.  I logged in using the Web interface and JUST changed the LAN IP to 192.168.10.1 -- I did not switch the LAN and WAN ports and I did NOT think about changing the LAN DHCP.

I tried to log into the new IP - and OpnSense did not reply.  I found comments that stated my issue was I did not set the LAN's DHCP when I changed the IP address.

I logged into the console as a Single User and performed Selection #2 - "Set Interface IP Address".  I set the IP back to 192.168.1.1 - 24, set DHCP from 192.168.1.2 to 192.168.1.199, set HTTP, and reset Web Gui - I did nothing to IP6 stuff.

When the system configures - it throws an error stating that line 233 of /user/local/etc/inc/system.inc is empty.

I've performed a CMOS reset per the Protectli tech support.  I performed a Factory Reset via the Console Menu (Same menu that I attempted to change the IP).

I'm NOT a linux guy - little to no knowledge.

I tried to nl the file system.inc (full path) from the console menu but that did not work hopping I would get an idea of the error.

THIS has got to be a common error as I can't be the only dumb shit that just changed the IP address and not the DHCP settings!!!

Any comments on how to fix or what to do?

Thanks

[bartjsmit]

I purchased a new Protectli 2420 with OpnSense installed.

If it is new, you won't have any configuration settings you need to keep. Perform a fresh install.

I'm NOT a linux guy - little to no knowledge.

That wouldn't do you much good anyway - OPNsense is based on FreeBSD  8)

Bart...