WG Road-warrior IPv6 setup

[pawlisko]

and turn off NAT rule - right?

[pawlisko]

Step 5(b) for IPv6 may not work when OPNsense receives an IPv6 prefix and does not assign itself an IPv6 address on the WAN interface.

Bug #1 - OPNsense didn't implement RFC6603; hence WAN interface does not have IPv6 address
Bug #2 - WG IPv6 addressing can't be NATed via Interface address as WAN Interface does not have an IPv6 address

Therefore NPTv6 works (avoiding Bug #2) while NAT66 does not.

Where this should be sent so developers can address it?