None of my VLAN interfaces are working after upgrade to 22.7

[Taomyn]

Thanks for the help and advice, that YouTube video helped as well.


So I added the parent and I also set the VLAN Hardware Filtering to "Default" ready for upgrading to 22.7 this weekend. Is is still recommended to keep all the other Hardware settings disabled or should I re-enable them and see what happens?


Also, is it normal for the main console to fill with these kinds of messages?

Code: [Select]


878.109862 [ 849] iflib_netmap_config       txr 2 rxr 2 txd 1024 rxd 1024 rbufsz 2048
igb2: permanently promiscuous mode enabled
878.165015 [ 849] iflib_netmap_config       txr 2 rxr 2 txd 1024 rxd 1024 rbufsz 2048
igb2: link state changed to DOWN
878.434815 [ 849] iflib_netmap_config       txr 2 rxr 2 txd 1024 rxd 1024 rbufsz 2048
878.715011 [ 849] iflib_netmap_config       txr 2 rxr 2 txd 1024 rxd 1024 rbufsz 2048
igb1: permanently promiscuous mode enabled
878.729169 [ 849] iflib_netmap_config       txr 2 rxr 2 txd 1024 rxd 1024 rbufsz 2048
igb1: link state changed to DOWN
igb1_vlan250: link state changed to DOWN
879.009875 [ 849] iflib_netmap_config       txr 2 rxr 2 txd 1024 rxd 1024 rbufsz 2048
igb2: link state changed to UP
igb1: link state changed to UP
igb1_vlan250: link state changed to UP


Over time it just fills up the screen.

[Taomyn]

Damn I spoke to soon and I noticed that my DMZ VLAN is no longer working and I can't access the machine that's connected there:





Any ideas?


For now I will revert back again and reboot as I need access to that machine to be working.

[Hellgirl]

Thanks a lot 

I have looked a few hours why a can´t reache my vlan´s.

The "Interface", "Settings" "VLAN Hardware Filtering" was set to "Disable Hardware Filtering" which brokes the vlan due the update vom 22.x to 22.7.

Set this setting before upgrade to "leave default" solved the problem on my Intel X520-DA2 ix0 10Gbit NIC.

The upgrade than works like expected absolutly seamless :-)

Thank´s all for this information!

[JamesFrisch]

Intel NUC 7th generation router on a stick here.

I set "Interface", "Settings" "VLAN Hardware Filtering" to default before upgrading.
Upgrade got stuck or something, after a hard reset, it came back up running 22.7.

Updating to 22.7.2 went smooth.

[enoch85]

I'm glad I found this! Exactly my issue as well, and this solved it.