Question regarding UI workflow for wireless devices

[cits]

Hi,

I was wondering what the reason behind the wireless device menu is.

As I was testing, i realized that I can not set the mode when adding a new wireless device and the default is always Infrastructure BSS. Since i don't have a card or even know if there are cards that support multiple modes of infra BSS, i can only add one interface at a time.

I find the configuration very strange because my card supports up to 3 wireless interfaces, but in order to add them I first have to assign it under the Interfaces menu, enable the interface, change the mode and then switch back to wireless devices to add a new one. I can't add all devices at once, since I can't pre-select the mode that I would like to run them in, while the mode itself is displayed in the Wireless menu and corrected according to the configuration in the Interface menu.

I could have sworn this wasn't the case with 2.1.1 and I am pretty sure that i could select modes when adding the devices on pfSense too.


I hope it doesn't sound like I'm nagging, please don't take it the wrong way.