wireguard assignment with wg0 (resolved)

[bucky2780]

I am working through the road warrior setup of wireguard in the opnsense docs.

when it comes to assignment/routing I have a showstopper that mystifies me.

I assign wg0 as an interface. But when I try to enable it I get the following error....

>>
The following input errors were detected:

    The DHCP Server is active on this interface and it can be used only with a static IP configuration. Please disable the DHCP Server service on this interface first, then change the interface configuration.
>>
However ipv4 config type is defined as (none)... so that can't be the problem.

really confusing... so any ideas are appreciated.

[bucky2780]

I deleted the existing wg0 assignment, and re-added it. I was able to save it while enabling it without getting the dhcp error. Looks like the uI was holding on to something....